National Paint
and Coatings Association Hazardous Material Identification System
Health Hazard:
1- Slight Flammability
Reactivity Hazard:
0 - Minimal
Flammability Hazard:
0 - Minimal
Personal Protection:
E - Glasses, Gloves, Dust Respirator
SECTION I - PRODUCT IDENTIFICATION
MirrorSEAL Penetrating Base Coat
Section II - HAZARDOUS INGREDIENTS
Section III - PHYSICAL DATA (1)
MirrorSEAL
is considered non-hazardous under the OSHA hazard communication standard
(29 CFR 1910-1200). None of the product's ingredients are found on
any list of hazardous, carcinogenic or banned chemical agents or
materials generated by them.
Chemical Name:
Materials:
Boiling
Ranges:
>212° Vapor Dennsity (air=1)
1
Odor:
Mild
Evaporation rate (BUOAC=1)
1 (for water)
Appearance:
White
(GM OF VOC less water)
0 gm/L
Solids by weight:
60%
Solubility
Miscible in water
Solids by volume:
41%
Specific density
1.5
Colorants by weight:
N.A.
PH
<7
(1) Typical amount, not a specification
SECTION IV -FIRE AND EXPLOSION HAZARD DATA
Flash Point:
Not Applicable
Flammable Limits :
UEL Not applicable
Method used :
Not Applicable
UEL Not applicable
EXTINGUSHING MEDIA: Water is recommended for cumbustible fiber containers of 50 gallons. This is a water-borne coating; it will not burn, unless all the water has evaporated. The dried polymer in the product will burn. In this case, use foam, carbon dioxide, dry chemicals or water.
SYSTEM DATA
MirrorSEAL: White colored, water-based continous-film emulsion adhesive coating.
Base coat, off-white.
MIRRORFAB: White, spun bound pollyester backbone fabric,
48" (1.22m) wide, wheight 2.2 oz per sq. yard. (75 gr/m2).
Coverage* 3 sq. ft. per lb. (0.62 m2/kg) for basecoat
12 sq. ft. per lb. (2.48 m2/kg) for topcoat
Mixing: Not required
Gel time: One hour
Dry time: Four hours or more depending on climatic conditions.
